However, after several years, even the best furnaces need to be repaired, and mobile home furnace parts will need to be replaced.When this happens, MobileHomePartsDepot.com is your number one resource.
Nordyne E2Eb 012Hb Furnace Blower Motor Replacement Instructions Full Range OfAt MobileHomePartsDepot.com, we carry a full range of Nordyne furnace replacement parts at highly discounted prices.
When you need a Nordyne furnace blower motor, heat-strip element or rewire kit, shop with us for a wide selection and top-notch customer service. Give us a call if you have any questions about the parts you need. WARNING: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. CAUTION: With system on, check temperature in all rooms. Partially close registers in rooms that are For optional AC or HP systems, too warm (in heating mode) or too cool (in always wait at least five minutes after cooling mode) and in rooms that are infre- the system shuts off before restarting quently occupied. E2EH models are equipped with Your E2 Series electric furnace is approved for the standard two-speed blower. E2EH models use with an optional central air conditioner or a can be easily converted for use with NORDYNE heat pump. Contact your nearest NORDYNE distributor for a complete list of electric furnace accessories. Also, the furnace rear mounting plate floor cavity is: Connector Model (see Figure 3) supplied with the plenum connec- English Metric (mm) Order No. Rear Mounting Plate Secure Plenum Connector Mtg Plate With 2 Flat Head Screws or Nails At Dimpled Locations Mounting Rear Wall. INSERT PLENUM CONNECTOR INTO DUCT CUT-OUT TABS Narrow Duct DUCT Duct 2. BEND BOTTOM TABS OVER AND ONTO THE UNDER- NEATH DUCT SURFACE Figure 10. Nordyne E2Eb 012Hb Furnace Blower Motor Replacement Instructions Install It ToPlenum Connector Installation A Connector Installation B If using optional rear mounting plate (sup- Method B plied with plenum connector), install it to. Downflow and Upflow Installations Secure front of unit with one or more fas- NOTE: Refer to the instructions supplied with teners at mounting hole(s) provided or at. Ensure that return air passage has no openings through support- ing structure that would permit flame or hot gases to travel from space below up into. NOTE: To install single-circuit kit, perform To avoid personal injury or property step 5. If single-circuit kit installation is not damage, make certain that the motor necessary, go to step 6. CB-A (See note 8) CB-A 2) Thermostat anticipator setting: 0.20 Amps. C thermoplastic copper wire of Grey Black 3) To change blower speeds on units without a relay box refer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |